Pyxia CNC

[Brian]

Hi,
I was searching for an example of rotated text (know I've got one somewhere),
and came across this. I converted it as well as I could, but it's not perfect...

It may have been written by Paul, but there was no clue

Nice if someone could take up the challenge and make it work properly

Brian

[LarryMc]

I played with it some.
There is a problem in the x,y calculations  somewhere because where G0 stops and G1 start and G1 stops and G0 starts aren't the same points and they should be.

I can't spot the problem code though.
If I had the source you used I might be able to figure it out.

LarryMc

[Brian]

Larry,

That was the source! I just tidied it up a bit for IWB. Although I can fish out
the original to see if there is any difference. There was a problem with a FLOAT
in a FOR-NEXT loop, if I remember rightly, so that could be a cause

Brian